2012年7月10日星期二

Still Using Twin-Adhensive To Fix PCB On Working Table? Out!


Still Using Twin-Adhensive To Fix PCB On Working Table? Out!


How to fix PCB on CNC wood router working table?
Are you a PCB workshop owner? How you fix PCB on CNC router working table? By twin adhensive? by clamp? After using adhensive, it is rather not eady to remove the adhensive, right? Well, if you use clamp, and 
when the PCB size is not small, then the middle section of PCB may can not fixed tightly, and cause lower resolution?
Today, OMNI suggest a good solution for PCB processing.  We use No.67 spray adhensive with 3M brand.
1. Clean the dust from PCB back and working table. Then spray out the No.67 adhensive to PCB back and leave the PCB for several min. 
2. Ensure working table is even, put PCB on table, start engraving and drilling.
3. NO.67 adhensive can be used repeatly for several days. So for next PCB, then still use it. If the back of PCB is with a little adhensive after processed by router cnc, then use 3M orange detergent to clean it. 

没有评论:

发表评论