2012年7月12日星期四

How To Engrave With CNC Wood Router?


How To Engrave With CNC Wood Router?

 How to Engrave With a CNC Wood Router
By Wade Shaddy, eHow Contributor
Learning how to hand engrave with a router can be very rewarding. Freehand engraving yields results that last forever. All you need is a small hand router. Draw your pattern on a piece of wood and establish your lines. Follow them with a router and a small engraving bit. Because you don't use guides to follow your patterns, it gives your engravings a custom, hand carved look. It's easy, fun and it's even safer than engraving with a knife. A popular grape-leaf pattern is traditional and easy to find, and is a good place to start.
Things You'll Need
Small hand router, 1/4-inch capacity
Router bit, 1/4-inch flute
2 wrenches that came with router
Pencil
Pattern
Pine, 6-by-24-by-3/4-inch
Grape leaf pattern
Scissors
2 hand clamps, 12-inch
1Download a grape leaf pattern of your choice and print it out. Cut out the pattern with scissors.
2Trace the pattern onto the pine. Clamp the pine to the edge of a worktable.
Sponsored Links
3Insert the flute bit into the router and tighten the retaining nut using the wrenches. Loosen the depth of cut adjustment on the side of the router and slide the router base so that 1/4 inch of the bit extends out the bottom of the router base. Tighten the depth of cut knob.
4Plug in the router. Hold the router base in both hands, position it over the pine. Reach up with your thumb and turn the cnc wood router on.
5Position the tip of the bit over the pencil lines and lower the bit into the wood. Let the sides of your palms on both hands rest on the wood as you hold the router between your hands.
6Begin following the lines, like you would with a large pen sliding the router along slowly as you trace over the pencil lines, letting the bit cut the design with the tip of the bit. Trace the entire design.
Tips & Warnings
Test the depth of your cut on a piece of scrap wood, or the back of your piece of pine before starting to engrave. When finished engraving, use a small piece of folded sandpaper to remove any feathered edges of the engraving lines.
Always wear safety glasses when working with wood. Make sure your router is turned off when you plug it in.

没有评论:

发表评论