What Can We Do If CNC Wood Router Cutter Stick Material Powder?

What can we do if cnc wood router cutte stick material powder in the processing?

Usually, there are two kinds of  cutter sticking situation:

1. Material powder melted on cutter.

Material powder melted on cutter, such appearance mainly occured when process non-metal material. The main reason is the cutting head cause material powder melted. Solutions are :

1) Using more sharp cnc wood router cutter;

2) Slow down spindle rotating speed. Slowing down spindle rotating speed could slow down the cutting speed, in this way, could reduce heat created, could avoid material melting;

3) Speed up feeding speed. Feeding speed get higher, then the time that cutter staying at one position is less, then the heat receiving for unit area will get less, avoidng material melt.

2. Material powder did not melted on cutter.

This problem mainly happened when process metal material. Reason is lower processing speed, more heat released. Solutions are :

1) Improve cooling way. Change the position of cooling liquid out-way, get the cooling liquid spray out at the cuttig position.

2) Use more sharp cutter. The cutter more sharper, the head more reduced.

3) Adjust cnc wood router spindle speed, speed up it.

4) Slow down feeding speed.